Answer in brief
CVE-2026-10674 records a Medium severity (CVSS 5.5) vulnerability in DoS (hard fault) in NXP LPUART driver: unsupported runtime UART config leaves clocks disabled. The current sources do not mark it as known exploited. The current feed maps zephyrproject/zephyr (generic). Check affected ranges and fixed versions before updating.
Analysis pending evidence review
HOL Guard separates source facts from reviewed analysis. See the methodology.
CVSS is 5.5. The current sources do not mark it as known exploited. Treat this as a source-backed prioritization signal, not a statement about your environment.
Analysis status
Analysis pending evidence review
Factual feed record only; HOL analysis is not approved for indexing. Read the methodology.
The current feed maps zephyrproject/zephyr (generic). Check affected ranges and fixed versions before updating.
| Package | Affected range | Fixed version |
|---|---|---|
| zephyrproject/zephyrgeneric | >=3.7.0 <4.3.1 || >=4.4.0 <4.4.2 | 4.3.1, 4.4.2 |
Published upstream
Jul 21, 2026
Evidence: source:cvelist:source_dates:source-dates:recordSource modified
Oct 15, 2026
Evidence: source:cvelist:source_dates:source-dates:recordFirst seen by HOL
Oct 15, 2026
The NXP LPUART serial driver (drivers/serial/uart_mcux_lpuart.c), when CONFIG_UART_USE_RUNTIME_CONFIGURE is enabled, called LPUART_Deinit() at the start of mcux_lpuart_configure(), which disables the LPUART peripheral clocks. The requested configuration is validated only afterwards (in mcux_lpuart_configure_basic), and unsupported parity/data-bit/stop-bit/flow-control values return -ENOTSUP before the clock is re-enabled. As a result, a uart_configure() request with an unsupported configuration left the LPUART in a clock-disabled state; any subsequent access to LPUART registers (poll_out/poll_in, interrupt handling, or a later reconfigure) faults on the gated peripheral and escalates to a hard fault, crashing the system. uart_configure() is a Zephyr syscall whose verifier (z_vrfy_uart_configure) only checks that cfg is readable user memory and forwards the caller-supplied configuration unchanged, so an unprivileged userspace thread with access to an LPUART device can deterministically trigger the fault, a persistent system-wide denial of service. Introduced in v2.5.0 and present in all subsequent releases until this fix, which removes the LPUART_Deinit() call and instead only disables the transmitter/receiver, leaving the clock running.
Quoted source text, attributed separately from HOL analysis.