frr: bgpd use-after-free of Tunnel Encapsulation sub-TLVs after a malformed attribute length from a peerCVE-2026-129456

In FRRouting, bgpd accepts a Tunnel Encapsulation attribute (type 23) whose outer TLV length does not match the length of the attribute: the mismatch is only logged and the attribute is processed anyway. A BGP neighbor can send UPDATE messages carrying such an attribute that put the reference count of the attribute's interned sub-TLV chain out of balance, so that the chain is freed while routes stored by bgpd (Adj-RIB-In entries and RIB paths) still point to it. When those routes are later replaced, withdrawn or cleared, for example when the session goes down, bgpd reads the freed memory, decrements a reference count inside it and frees it a second time. In the reporter's build without AddressSanitizer this ended in an assertion failure in bgpd's memory accounting, aborting bgpd and dropping all BGP sessions on the router, and the neighbor can repeat it each time bgpd restarts. Because freed heap memory is written to and freed again, consequences beyond a crash cannot be ruled out. An established BGP session is required. bgpd processes attribute 23 from every neighbor, including eBGP neighbors, unless it is explicitly discarded, although RFC 9012 requires it to be filtered on eBGP sessions by default. The issue was reproduced with "soft-reconfiguration inbound" configured for the neighbor, and the reporter observed that the crash does not occur on every attempt.

Quoted source text, attributed separately from HOL analysis.